4PPC30.101G-21B

General information
Support
Controller redundancy No
ACOPOS support No
Visual Components support Yes
Safety support No
Certifications
CE Yes
UKCA Yes
UL cULus E115267
Industrial control equipment
B&R ID code 0xF358
Cooling Passive
Power button No
Reset button Yes
Status indicators Supply voltage OK, operating state, module status, Ethernet, CAN Rx/Tx
Buzzer Yes
Controller
Processor
L1 cache
Data code 24 kB
Program code 32 kB
Type ARM Cortex-A8
Clock frequency 1 GHz
L2 cache 256 kB
Application memory
Writable data amount
Guaranteed 40 TB
Results for 5 years 21.9 GB/day
Type 512 MB flash memory
Data retention 10 years
Guaranteed erase/write cycles 20,000
Error-correcting code (ECC) Yes
Storage health data support Yes, AR 4.90 and later
Bootloader Automation Runtime AR 4.09
Real-time clock Nonvolatile, resolution 1 s, -10 to 10 ppm accuracy at 25°C
Floating point unit (FPU) Yes
Mode/Node switches No
Remanent variables 8 kB FRAM, retention >10 years
DRAM 256 MB
Shortest task class cycle time 1 ms
Typical instruction cycle time 0.01 μs
Temperature cutoff No
Display
Viewing angles
Horizontal Direction L / Direction R = Typ. 80°
Vertical Direction U / Direction D = Typ. 80°
Backlight
Type LED
Brightness Typ. 500 cd/m²
Half-brightness time 50,000 h
Touch screen
Type AMT
Technology Analog resistive
Controller B&R, 12-bit
Transmittance 80% ±3%
Type TFT color
Diagonal 10.1"
Colors 16.7 million (RGB, 8 bits per channel)
Resolution WSVGA, 1024 x 600 pixels
Contrast Typ. 500:1
Screen rotation Yes
Interfaces
Interface IF1
Type USB 2.0
Variant Type A
Current-carrying capacity 0.49 A
Interface IF2
Type USB 2.0
Variant Type A
Current-carrying capacity 0.49 A
Interface IF3
Transfer
Physical layer 10BASE-T/100BASE-TX
Half-duplex Yes
Full-duplex Yes
Autonegotiation Yes
Auto-MDI/MDIX Yes
Type Ethernet
Variant 1x RJ45 shielded
Line length Max. 100 m between 2 nodes (segment length)
Max. transfer rate 10/100 Mbit/s
Interface IF4
Max. transfer rate
Bus length ≤25 m 1 Mbit/s
Bus length ≤60 m 500 kbit/s
Bus length ≤200 m 250 kbit/s
Bus length ≤1000 m 50 kbit/s
Type CAN bus
Variant 3 pins of the 6-pin multipoint connector
Max. distance 1000 m
Bus terminating resistor 120 Ω, switchable using software
Interface IF6
Max. transfer rate
Bus length ≤25 m 1 Mbit/s
Bus length ≤60 m 500 kbit/s
Bus length ≤200 m 250 kbit/s
Bus length ≤1000 m 50 kbit/s
Type CAN bus
Variant 3 pins of the 6-pin multipoint connector
Max. distance 1000 m
Terminating resistor 120 Ω, switchable using software
Electrical properties
Nominal voltage 24 VDC -15% / +20%
Power consumption Typ. 6.5 W / Max. 12.5 W
Fuse 3 A slow-blow, internal
Reverse polarity protection Yes
Electrical isolation Ethernet (IF3) to other interfaces and to device
Operating conditions
Installation elevation above sea level
0 to 2000 m No limitation
>2000 m Reduction of ambient temperature by 0.5°C per 100 m
Degree of protection per EN 60529 Front: IP65, Back: IP20
Degree of protection per UL 50 Type 1
Ambient conditions
Temperature
Operation -20 to 60°C
Storage -25 to 70°C
Transport -25 to 70°C
Relative humidity 5 to 95%, non-condensing
Mechanical properties
Front
Design Anthracite gray pinstripe
Dimensions
Width 276 mm
Height 172 mm
Depth 47.8 mm
Weight 0.9 kg
Malzeme numarası:
4PPC30.101G-21B
Açıklama:
Power Panel C30, 10.1", landscape format, fieldbus interfaces: 2x CAN bus. CPU and memory: 1 GHz (ARM Cortex-A8), 256 MB DDRAM, 8 kB FRAM, 512 MB onboard flash drive. Display and touch screen: 10.1", 1024 x 600 (WSVGA) resolution, analog resistive touch screen, landscape format, anthracite gray pinstripe. Interfaces: 1x Ethernet 10/100 Mbit/s, 2x USB 2.0, 2x CAN bus.
Teslimata dahil
Terminal blocks
0TB6102.2110-01 Accessory terminal block, 2-pin (3.81), cage clamp terminal block 1.5 mm²
0TB5106.2110-01 Accessory terminal block, 6-pin (2.5), cage clamp terminal block 0.5 mm²
İsteğe bağlı aksesuarlar
Accessories
9A0013.01 Stylus pen for resistive touch screen
Other
6ACCRPP3.0000-000 Installation kit for Power Panel C-Series variants: 9x retaining clip with torque limiting, 1x 2-pin cage clamp terminal block, 1x 2-pin screw clamp terminal block, 1x 4-pin cage clamp terminal block, 1x 6-pin cage clamp terminal block. See the accessories of the Power Panel variant in the corresponding data sheet or on the website.
Terminal blocks
0TB6102.2010-01 Accessory terminal block, 2-pin (3.81), screw clamp terminal block 1.5 mm²
USB accessories
5MMUSB.4096-01 USB 2.0 flash drive 4096 MB B&R
5MMUSB.2048-01 USB 2.0 flash drive 2048 MB B&R
Automation Studio donanım yükseltmeleri Sürüm (Tarih) İndirme
V4.2 HW Upgrade (4PPC30.101G-21B) EXE / 5 MB
Dökümantasyon Sürüm (Tarih) İndirme
Installation- / EMC-Guide PDF / 20 MB
Power Panel C30 Model number key PDF / 121 KB
Power Panel C30 user's manual PDF / 61 MB
E-CAD (Elektro veya EPLAN şablonları) Sürüm (Tarih) İndirme
Makro-/Artikeldaten 4.0.0 (4PPC30.101G-21B) EXE / 671 KB
Makro-/Artikeldaten 4.0.0 (4PPC30.101G-21B) EXE / 671 KB
Panel EPLAN P8 from V2.4 EXE / 67 MB
M-CAD (Mechan. Şablonlar) Sürüm (Tarih) İndirme
3D-files DXF/STEP: Power Panel C30 10.1 ZIP / 4 MB
Sertifikalar Sürüm (Tarih) İndirme
UL61010-1 Certificate of Compliance C30, C50, T50 Series PDF / 230 KB

Lütfen ülke ve dil seçin

B&R Logo