8BVP0440HC00.000-1

General information
B&R ID code 0xA073
Support
Dynamic node allocation (DNA) Yes
Cooling and mounting type Cold plate or pass-through mounting
Slots for plug-in modules 2
Certifications
CE Yes
UKCA Yes
UL cULus E225616
Power conversion equipment
EAC Yes
KC Yes
Mains connection
Network configurations TT, TN-S, TN-C-S
Mains input voltage 3x 220 to 3x 480 VAC ±10%
Frequency 50 / 60 Hz ±4%
Installed load Max. 31.1 kW
Inrush current at 400 VAC Max. 67 A
Switch-on interval >300 s
Max. chargeable DC bus capacitance depending on mains voltage
230 VAC 17.4 mF
400 VAC 5.8 mF
480 VAC 4 mF
Nominal switching frequency 5 kHz
Possible switching frequencies 5 / 10 kHz
Integrated line filter per EN 61800-3, category C3 No
Integrated regeneration choke No
Regenerative Yes
Power factor correction (PFC) Yes
Variant
L1, L2, L3, PE Connector
PE M5 threaded bolt
Shield connection Yes
Terminal connection cross section
Flexible and fine-stranded wires
With wire end sleeves 0.5 to 16 mm²
Approbation data
UL/C-UL-US 20 to 6 AWG
CSA 20 to 6 AWG
Terminal cable cross section dimension of shield connection 23 to 35 mm
DC bus connection
Voltage
Nominal 750 VDC
Continuous power (supply and regeneration) 30 kW
Reduction of continuous power depending on mains input voltage
Mains input voltage <3x 400 VAC 75 W/V * (400 V - Mains input voltage)
Reduction of continuous power depending on DC bus voltage (UDC)
UDC <750 VDC P * (1 - UDC/750)
Reduction of continuous power depending on switching frequency and mounting type
Switching frequency 5 kHz
Cold plate mounting 0.56 kW/K (starting at 45°C)
Pass-through mounting In preparation
Switching frequency 10 kHz
Cold plate mounting 0.43 kW/K (starting at 6°C)
Pass-through mounting In preparation
Reduction of continuous power depending on installation elevation
Starting at 500 m above sea level 3 kW per 1000 m
Peak power (supply and regeneration) 60 kW
Reduction of peak power depending on mains input voltage
Mains input voltage <3x 400 VAC 150 W/V * (400 V - Mains input voltage)
Power dissipation depending on switching frequency
Switching frequency 5 kHz [0.15*P²+10.5*P+40] W
Switching frequency 10 kHz [0.42*P²+16*P+130] W
DC bus capacitance 825 µF
Protective measures
Overload protection Yes
Short-circuit and ground fault protection No
Variant ACOPOSmulti backplane
24 VDC power supply
Input voltage 25 VDC ±1.6%
Input capacitance 4.7 µF
Max. power consumption 25 W + PSLOT1 + PSLOT2 + P24 V Out + PFan8BVF...
Variant ACOPOSmulti backplane
24 VDC Out
Quantity 2
Output voltage
DC bus voltage (UDC): 260 to 315 VDC 25 VDC * (UDC / 315)
DC bus voltage (UDC): 315 to 800 VDC 24 VDC ±6%
Fuse protection 250 mA (slow-blow) electronic, automatic reset
Filter fan connection
Output voltage 24 V +5.8% / -0.1%
Continuous current 4.2 A
Max. overcurrent limiting 10 A
Protective measures
Overload protection No
Short-circuit proof Yes
Open-circuit monitoring No
Undervoltage monitoring No
Trigger inputs
Quantity 2
Circuit Sink
Electrical isolation
Input - Power supply module Yes
Input - Input Yes
Input voltage
Nominal 24 VDC
Maximum 30 VDC
Switching threshold
Low <5 V
High >15 V
Input current at nominal voltage Approx. 10 mA
Switching delay
Rising edge 52 μs ±0.5 μs (digitally filtered)
Falling edge 53 μs ±0.5 μs (digitally filtered)
Modulation compared to ground potential Max. ±38 V
Electrical properties
Discharge capacitance 0.9 µF
Operating conditions
Permissible mounting orientations
Hanging vertically Yes
Horizontal, face up Yes
Standing horizontally No
Installation elevation above sea level
Nominal 0 to 500 m
Maximum 4000 m
Pollution degree per EN 61800-5-1 2 (non-conductive pollution)
Overvoltage category per EN 61800-5-1 III
Degree of protection per EN 60529 IP20
Ambient conditions
Temperature
Operation
Nominal 5 to 40°C
Maximum 55°C
Storage -25 to 55°C
Transport -25 to 70°C
Relative humidity
Operation 5 to 85%
Storage 5 to 95%
Transport Max. 95% at 40°C
Mechanical properties
Dimensions
Width 106.5 mm
Height 317 mm
Depth
Cold plate 212 mm
Pass-through mounting 209 mm
Weight Approx. 4.5 kg
Module width 2
Номер модель:
8BVP0440HC00.000-1
Описание:
  • Wide input voltage range
  • Regenerative
  • Integrated connection for temperature sensor
  • 2 slots for ACOPOSmulti plug-in modules
ACOPOSmulti power supply module, 44 A, AS, cold plate or pass-through mounting
Обязательные аксессуары
Terminal block sets
8BZVP044000.000-1A Screw clamp terminal block set for ACOPOSmulti 8BVP0220Hx00 and 8BVP0440Hx00 modules: 1x 8TB2106.2010-00, 1x 8TB2108.2010-00, 1x 8TB2104.204A-00, 1x 8TB4104.202L-10
Дополнительные аксессуары
Accessory sets
8BXB000.0000-00 ACOPOSmulti accessory set for encoder buffering consisting of: 1x battery AA 3.6 V, 1x protective cover for battery holder
Fan modules
8BXF001.0000-00 Модуль вентилятора для ACOPOSmulti, сменный вентилятор для модулей ACOPOSmulti (8BxP/8B0C/8BVI/8BVE/8B0K)
POWERLINK/Ethernet cables
X20CA0E61.00020 Соединительный кабель POWERLINK/Ethernet, RJ45 – RJ45, длина 0,2 м
X20CA0E61.00025 Соединительный кабель POWERLINK, RJ45 – RJ45, 0,25 м
X20CA0E61.00030 Соединительный кабель POWERLINK, RJ45 – RJ45, 0,3 м
X20CA0E61.00035 Соединительный кабель POWERLINK, RJ45 – RJ45, 0,35 м
X20CA0E61.00050 Соединительный кабель POWERLINK/Ethernet, RJ45 – RJ45, длина 0,5 м
X20CA0E61.00100 Соединительный кабель POWERLINK/Ethernet, RJ45 – RJ45, длина 1 м
Plug-in modules
8BAC0120.000-1 ACOPOSmulti plug-in module, EnDat 2.1 interface
8BAC0120.001-2 ACOPOSmulti plug-in module, EnDat 2.2 interface
8BAC0121.000-1 ACOPOSmulti plug-in module, HIPERFACE interface
8BAC0122.000-1 ACOPOSmulti plug-in module, resolver interface 10 kHz
8BAC0123.000-1 ACOPOSmulti plug-in module, incremental encoder and SSI absolute encoder interface for RS422 signals
8BAC0123.001-1 ACOPOSmulti plug-in module, incremental encoder interface for 5 V single-ended and 5 V differential signals
8BAC0123.002-1 ACOPOSmulti plug-in module, incremental encoder interface for 24 V single-ended and 24 V differential signals
8BAC0124.000-1 ACOPOSmulti plug-in module, SinCos interface
8BAC0125.000-1 ACOPOSmulti plug-in module, SinCos EnDat 2.1/SSI/BiSS interface
8BAC0130.000-1 ACOPOSmulti plug-in module, 2 digital outputs, 50 mA, max. 62.5 kHz, 2 digital outputs, 500 mA, max. 1.25 kHz, 2 digital inputs 24 VDC
8BAC0130.001-1 ACOPOSmulti plug-in module, 2 digital outputs, 50 mA, max. 62.5 kHz, 4 digital outputs, 500 mA, max 1.25 kHz
8BAC0132.000-1 ACOPOSmulti plug-in module, 4 analog inputs ±10 V
8BAC0133.000-1 ACOPOSmulti plug-in module, 3 RS422 outputs for ABR encoder emulation, 1 MHz
Shield component sets
8SCS002.0000-00 Набор компонентов для экранирования ACOPOSmulti: 1 зажимная планка, 2 хомута D 4-13,5 мм, 2 винта
8SCS005.0000-00 ACOPOSmulti shield component set: 1x slot cover / shield plate
8SCS007.0000-00 ACOPOSmulti shield component set: 1x shield mounting plate 2x 45°, 4x screws
8SCS008.0000-00 ACOPOSmulti shield component set: 1x shield plate 2x type 0, 1x hose clamp, B 9 mm, D 23-35 mm
8SCS010.0000-00 Набор компонентов для экранирования ACOPOSmulti: 1 пластина для крепления экрана ACOPOSmulti SK14-20, 1 зажим для крепления экрана SK20
Terminal blocks
8TB2104.204A-00 4-pin screw clamp terminal block, 1-row, pitch: 5.08 mm, label 4: T- T+ F- F+, coding A: 0000
8TB2106.2010-00 6-pin screw clamp terminal block, 1-row, pitch: 5.08 mm, label 1: Numbered consecutively
8TB2108.2010-00 8-контактная с винтовыми зажимами, однорядная, расстояние между контактами: 5,08 мм, метка 1: пронумерованы последовательно
8TB4104.202L-10 Screw clamp terminal block 4-pin, one-row, pitch: 10.16 mm, label 2: PE L3 L2 L1, coding L: 1010
E-CAD (Electro или EPLAN шаблоны) Версия (Дата) Загрузка
ACOPOSmulti EPLAN P8 from V2.4 EXE / 81 МБ
M-CAD (Механические Шаблоны Версия (Дата) Загрузка
3D file STEP 8BVP0xx0HC00.000-1 ZIP / 151 кБ
Документация Версия (Дата) Загрузка
ACOPOSmulti User´s Manual PDF / 302 МБ
Datasheet 8BVP0440HC00.000-1 PDF / 4 МБ
Обновление Automation Studio HW Версия (Дата) Загрузка
V3.0 HW Upgrade (8B0PXXXXXXXX.XXX-X) EXE / 399 кБ
V4.0 HW Upgrade (8BVP0440HC00.000-1) EXE / 306 кБ
V4.0 HW Upgrade (8BVPxxxxxxxx.xxx-1) EXE / 676 кБ
Сертификаты Версия (Дата) Загрузка
ACOPOSmulti KC certificates ZIP / 3 МБ
E225616 UL Certificate of Compliance ACOPOSmulti (UL 508C) PDF / 282 кБ
EAC Conformity declaration 8B power sources PDF / 1 МБ
EU Declaration Servos ACOPOSmulti PDF / 219 кБ
UK Declaration Servos ACOPOSmulti PDF / 109 кБ

Укажите страну и язык

B&R Logo