DWL@DWL10000103205
| Version | Langue | Système d'exploitation | Date | Taille | Type | Téléchargement |
|---|---|---|---|---|---|---|
| 1.0.8.0 | * | 04/11/2010 | 650 KB | EXE | AS2.6_HW_5PC600.SE00-01.exe | |
| Description |
V2.7 HW Upgrade (5PC600.SE00-01) Revision information 5PC600.SE00-01: Version 1.0.1.0: ID#179620: AR106: USB extension for AP900 Channel description changed: No Configuration description changed: No Firmware changed: No Version 1.0.2.0: ID#180175: Powerlink settings extended Channel description changed: No Configuration description changed: No Firmware changed: No Version 1.0.3.0: ID#188550: APC620e project cannot be compiled if the hardware was loaded from the target system ID#189305: Powerlink BugFix (MII Communication Pull Up resistor) Channel description changed: No Configuration description changed: No Firmware changed: No ID#189310: New CAN IP for SJA1000 integrated Channel description changed: No Configuration description changed: No Firmware changed: No Version 1.0.4.0: ID#194835: Problems wiht reading the CAN node-switches After changing the SJA1000 IP the CAN node-switches were not readable. Alsoa new EPL IP and firmware has been integrated. Channel description changed: No Configuration description changed: No Firmware changed: Yes Version 1.0.5.0: ID#207920: New POWERLINK firmware V45 and basis firmware V15 POWERLINK V2 CN mode: - Frequent MN failures result in CPU going into Service mode. - The PollResponse data from multiplexed stations are now updated in every POWERLINK cycle. Channel description changed: No Configuration description changed: No Firmware changed: Yes Version 1.0.6.0: ID#213105: CN mode: Various error corrections made. Channel description changed: No Configuration description changed: No Firmware changed: Yes Version 1.0.7.0: ID#224155: New PLK and new CAN firmware POWERLINK V2: Boot behavior improved CAN: TransmitQueue Reset command corrected CAN: Filter on CAN RX installed Channel descriptionchanged: No Configuration description changed: No Firmware changed:Yes Version 1.0.8.0: ID#242580: POWERLINK Firmware and I/O Datapoint - update POWERLINK Firmware V106 - Link OK status as I/O datapoint for Powerlink added Channel description changed: Yes Configuration description changed: Yes Firmware changed: Yes Version 2.0.0.1: ID#242920: POWERLINK Firmware and I/O Datapoint - update POWERLINK Firmware V106 - Link OK status as I/O datapoint for Powerlink added Channel description changed: Yes Configuration description changed: Yes Firmware changed: Yes |
|||||
