DWL@DWL10000103204
| Version | Langue | Système d'exploitation | Date | Taille | Type | Téléchargement |
|---|---|---|---|---|---|---|
| 1.0.8.0 | * | 04/11/2010 | 655 Ko | EXE | AS2.6_HW_5PC600.SE00-00.exe | |
| Description |
V2.7 HW Upgrade (5PC600.SE00-00) Revision information 5PC600.SE00-00: Version 1.0.0.1: ID#172420: Support 5PC600.SE00-00 Version 1.0.1.0: ID#179615: AR106: USB extension for AP900 Channel description changed: No Configuration description changed: No Firmware changed: No Version 1.0.2.0: ID#180160: Powerlink settings extended Channel description changed: No Configuration description changed: No Firmware changed: No Version 1.0.3.0: ID#185730: APC620e project cannot be compiled if the hardware was loaded from the target system Channel description changed: No Configuration description changed: No Firmware changed: No ID#188585: Powerlink BugFix (MII Communication Pull Up resistor) Channel description changed: No Configuration description changed: No Firmwarechanged: No ID#189070: New CAN IP for SJA1000 integrated Channel description changed: No Configuration description changed: No Firmware changed: No Version 1.0.4.0: ID#194830: Problems wiht reading the CAN node-switches After changing the SJA1000 IP the CAN node-switches were not readable. Alsoa new EPL IP and firmware has been integrated. Channel description changed: No Configuration description changed: No Firmware changed: Yes Version 1.0.4.1: ID#200725: New EPL Firmware (V44) integrated CN mode: Various errorcorrections made. Channel description changed: No Configuration description changed: No Firmware changed: Yes Version 1.0.5.0: ID#207530: New POWERLINK firmware V45 and basis firmware V15 POWERLINK V2 CN mode: - Frequent MN failures result in CPU going into Service mode. - The PollResponse data from multiplexed stations are now updated in every POWERLINK cycle. Channel description changed: No Configuration description changed: No Firmware changed: Yes Version 1.0.6.0: ID#213100: CN mode: Various error corrections made. Channel description changed: No Configuration description changed: No Firmware changed: Yes Version 1.0.7.0: ID#223850: NewPLK and new CAN firmware POWERLINK V2: Boot behavior improved CAN: TransmitQueue Reset command corrected CAN: Filter on CAN RX installed Channel description changed: No Configuration description changed: No Firmware changed: Yes Version 1.0.8.0: ID#242550: POWERLINK Firmware and I/O Datapoint - update POWERLINK Firmware V106 - Link OK status as I/O datapoint for Powerlink added Channel description changed: Yes Configuration description changed: Yes Firmware changed: Yes Version 2.0.0.1: ID#242900: POWERLINK Firmware and I/O Datapoint - update POWERLINK Firmware V106 - Link OK status as I/O datapoint for Powerlink added Channel description changed: Yes Configuration description changed: Yes Firmware changed: Yes |
|||||
