General information
Controller
| Processor | netX 100 |
| Dual-port memory | 64 kB |
Fieldbus
| Type | CANopen master |
| Variant | DSUB, 9-pin, male |
| Transfer rate | 10 kbit/s to 1 Mbit/s |
| Slaves | Max. 126 |
| Cyclic data | Max. 7168 bytes |
| SDO upload and download | Max. 200 bytes/request |
| Emergency | Consumer/Producer |
| Functions | Node/Life guard., heartbeat, PDO mapping, NMT management, SYNC |
| PDO communication | synchronized, remotely requested and event-driven (change of state) max. 512 Rx/TxPDO |
Electrical properties
| Nominal voltage | +3.3 V ±5% |
| Nominal current | 650 mA |
Ambient conditions
| Temperature | |
| Operation | 0 to 55°C |
Mechanical properties
| Dimensions | |
| Width | 120 mm |
| Height | 73.2 mm |
| Depth | 18.5 mm |
| Slot | Standard PCI half-size module, plug and play |
| Installation in | |
| B&R Automation PC | Yes |
| B&R Panel PC | Yes |
| Desktop PC | Yes |
Materiaalnummer:
5ACPCI.XCOM-00Omschrijving:
The 5ACPCI.XCOM-00 is equipped with a CANopen master interface and can therefore be used as a master in a CANopen network. Data is exchanged via the dual port memory.
| Automation Studio HW Upgrades | Versie (Datum) | Download |
|---|---|---|
| V3.0 HW Upgrade (5ACPCI.XCOM-00) | EXE / 600 KB | |
| V4.0 HW Upgrade (5ACPCI.XCOM-00) | EXE / 886 KB |
| Documentatie | Versie (Datum) | Download |
|---|---|---|
| B&R Hilscher Fieldbus cards | PDF / 3 MB | |
| Datasheet 5ACPCI.XCOM-00 | PDF / 462 KB |
| E-CAD (Electro of EPLAN Templates) | Versie (Datum) | Download |
|---|---|---|
| APC EPLAN P8 from V2.4 | EXE / 99 MB |
| Firmware Upgrades | Versie (Datum) | Download |
|---|---|---|
| Hilscher firmware (5ACPCI.XCOM-00) | ZIP / 212 KB |