Please choose country and language

Short description
I/O module 4 digital outputs 250 VDC / 240 VAC, outputs single-channel isolated
General information
B&R ID code 0xF76A
Status indicators I/O function per channel, operating state, module status
Diagnostics
Module run/error Yes, using LED status indicator and software
Outputs Yes, using LED status indicator
Power consumption
Bus 1.1 W
Internal I/O -
Additional power dissipation caused by actuators (resistive) [W] +0.32
Certifications
CE In preparation
Digital outputs
Variant Relay: 2 normally open contacts and 2 changeover contacts
Channels are single-channel isolated.
Nominal voltage 250 VDC / 240 VAC
Max. voltage 277 VAC
Switching voltage Max. 250 VDC / 277 VAC
Rated frequency DC / 45 to 63 Hz
Nominal output current DC: See section "DC switching capacity".
AC: 2 A at 240 VAC
Total nominal current DC: See section "DC switching capacity".
AC: 8 A at 240 VAC
Actuator power supply External
Inrush current Max. 8 A (per channel)
Contact resistance Max. 100 mΩ
Switching delay
0 → 1 Normally open contact ≤15 ms / Changeover contact ≤19 ms
1 → 0 Normally open contact ≤11 ms / Changeover contact ≤15 ms
Isolation voltages
Channel - Bus Tested at 3500 VAC
Channel - Channel Tested at 1700 VAC
Channel - Ground Tested at 3500 VAC
Service life
Electrical 105 at 2 A (normally open and changeover contact)
Mechanical 30 x106 cycles (normally open and changeover contact)
Switching capacity
Minimum 0.12 W DC / 2.4 W AC
Maximum DC: See section "DC switching capacity".
AC: 480 W
Protective circuit
Internal None
External
AC RC combination or VDR
DC Inverse diode, RC combination or VDR
Electrical properties
Electrical isolation Channel isolated from channel and bus
Operating conditions
Mounting orientation
Horizontal Yes
Vertical Yes
Installation elevation above sea level
0 to 2000 m No limitation
>2000 m Not permitted
Degree of protection per EN 60529 IP20
Ambient conditions
Temperature
Operation
Horizontal mounting orientation -25 to 60°C
Vertical mounting orientation -25 to 50°C
Derating -
Storage -40 to 85°C
Transport -40 to 85°C
Relative humidity
Operation 5 to 95%, non-condensing
Storage 5 to 95%, non-condensing
Transport 5 to 95%, non-condensing
Mechanical properties
Note Order 1x terminal block X20TB32 separately.
Order 1x bus module X20BM32 separately.
Spacing 25 +0.2 mm
Material number:
X20DO4F49
Description:
  • 4 digital outputs
  • Relay module for 250 VDC / 240 VAC
  • 2 normally open contacts and 2 changeover contacts
  • Single-channel isolated outputs

This module is equipped with 4 relay outputs. It can switch DC voltages up to 250 VDC and is therefore suitable for use in power generation systems.

Mandatory Accessories
Bus modules
X20BM32 X20 bus module for double-width modules, 240 VAC keyed, internal I/O supply continuous
Terminal blocks
X20TB32 X20 terminal block, 12-pin, 240 VAC keyed
Automation Studio HW Upgrades Version (Date) Download
V4.0 HW Upgrade (X20DO4F49) EXE / 568 KB
Documentation Version (Date) Download
Data sheet X20DO4F49 PDF / 232 KB

Please choose country and language

B&R Logo