Please choose country and language

General information
Dongle port Yes
LEDs Power, CF, Link, Run, CAN, POWERLINK, IF slot
B&R ID code 0xA7DE
Battery
Type Renata 950 mAh
Service life 2 years
Removable Yes, accessible behind the cable cover
Variant Lithium Ion
Power button Yes
Reset button Yes
Buzzer Yes
Cooling and mounting type Cold plate or feed-through mounting
Certifications
CE Yes
UL cULus E115267
Industrial control equipment
Controller
Bootloader BIOS
Cooling Passive via heat sink and supported with an active fan kit
Real-time clock
Accuracy At 25°C: typ. 12 ppm (1 seconds) per day
Battery-backed Yes
Power failure logic
Controller MTCX
Buffer time 10 ms
Graphics
Controller Intel Graphics Media Accelerator 950
SRAM
Size 1 MB
Battery-backed Yes
Remanent variables in power failure mode 128 kB (e.g. for Automation Runtime, see AS help system)
Interfaces
COM1
Type RS232, modem-capable, not electrically isolated
Variant 9-pin, male, DSUB connector
UART 16550-compatible, 16-byte FIFO
Max. baud rate 115 kbit/s
COM2
Type RS232/422/485, electrically isolated
Variant 9-pin, male, DSUB connector
UART 16550-compatible, 16-byte FIFO
Max. baud rate 115 kbit/s
CompactFlash slot 1
Type Type I
CompactFlash slot 2
Type Type I
USB
Quantity 5
Type USB 2.0
Connection To each USB type A interface
Transfer rate Low speed (1.5 Mbit/s), full speed (12 Mbit/s), high speed (480 Mbit/s)
Current-carrying capacity Max. 500 mA or 1 A per interface
Ethernet
Quantity 2
Transfer rate 10/100/1000 Mbit/s
Max. baud rate 1000 Mbit/s
Panel/Monitor interface
Variant DVI-I
Type SDL/DVI/Monitor
POWERLINK
Quantity 1
Node switches 2
Status LED Yes
CAN
Quantity 1
Transfer rate Max. 500 kbit/s
Node switches Yes
Status LED Yes
Terminating resistor Yes, can be activated using a switch
Slots
PCIec slots
Quantity 1
Electrical properties
Nominal voltage 24 VDC ±25%
Nominal current 5 A
Inrush current Typ. 7 A, max. 50 A for < 300 µs
Operating conditions
Drop height 0.25 m
Degree of protection per EN 60529 IP20
Ambient conditions
Temperature
Operation Component-dependent
Storage -20 to 60°C
Transport -20 to 60°C
Relative humidity
Operation Component-dependent
Storage Component-dependent
Transport Component-dependent
Vibration
Operation 2 to 9 Hz: 0.3 mm amplitude / 9 to 200 Hz: 0.1 g
Storage 2 to 9 Hz: 3.5 mm amplitude / 9 to 200 Hz: 1 g / 200 to 500 Hz: 1.5 g
Transport 2 to 9 Hz: 3.5 mm amplitude / 9 to 200 Hz: 1 g / 200 to 500 Hz: 1.5 g
Elevation
Operation Max. 3000 m (component-dependent)
Mechanical properties
Housing
Material Galvanized plate, plastic
Front cover Polycarbonate, black
Cable cover Polycarbonate, transparent
Dimensions
Width 53 mm
Height 344 mm
Depth 205 mm
Weight Approx. 1850 g
Material number:
5PC820.SX01-00
Description:
  • Specially developed to operate together with ACOPOSmulti
  • Cold plate or feed-through mounting
  • 1 PCI Express compact slot
  • SRAM, 1 MB onboard
  • Integrated POWERLINK and CAN fieldbus interfaces
APC820 system unit, cold plate mounting, 1 PCIec card slot; 2x CompactFlash slot, 1x RS232, 1x RS232/422/485, 1x POWERLINK, 1x CAN, Smart Display Link/DVI/Monitor, 5x USB 2.0, 2x ETH 10/100/1000, 24 VDC over the ACOPOSmulti busbar.
Mandatory Accessories
CPU boards
5PC800.B945-10 Intel Core Duo L2400 CPU board, 1.66 GHz, dual core, 667 MHz FSB, 2 MB L2 cache; 945GME chipset; 2 slots for SO-DIMM DDR2 modules (max. total of 3 GB), Realtek RTL8111C Ethernet controller
5PC800.B945-11 Intel Core2 Duo L7400 CPU board, 1.5 GHz, dual core, 667 MHz FSB, 4 MB L2 cache; 945GME chipset; 2 slots for SO-DIMM DDR2 modules (max. total of 3 GB), Realtek RTL8111C Ethernet controller
5PC800.B945-12 Intel Core2 Duo U7500 CPU board, 1.06 GHz, dual core, 533 MHz FSB, 2 MB L2 cache; 945GME chipset; 2 slots for SO-DIMM DDR2 modules (max. total of 3 GB), Realtek RTL8111C Ethernet controller
5PC800.B945-13 Intel Celeron M 423 CPU board, 1.06 GHz, single core, 533 MHz FSB, 1 MB L2 cache; 945GME chipset; 2 slots for SO-DIMM DDR2 modules (max. total of 3 GB), Realtek RTL8111C Ethernet controller
5PC800.B945-14 Intel Core2 Duo T7400 CPU board, 2.16 GHz, dual core, 667 MHz FSB, 4 MB L2 cache; 945GME chipset; 2 slots for SO-DIMM DDR2 modules (max. total of 3 GB), Realtek RTL8111C Ethernet controller
Heat sinks
5AC802.HS00-00 APC820 power supply and heat sink for CPU boards with Dual Core processors L2400, L7400, U7500 and Celeron M 423.
5AC802.HS00-01 APC820 power supply with heat sink for CPU boards with dual-core processor T7400.
Undefined
5MMDDR.0512-01 SO-DIMM DDR2 RAM 512 MB PC2-5300
5MMDDR.1024-01 SO-DIMM DDR2 RAM 1024 MB PC2-5300
5MMDDR.2048-01 SO-DIMM DDR2 RAM 2048 MB PC2-5300
Optional Accessories
Fan modules
8BXF001.0000-00 ACOPOSmulti fan module, replacement fan for ACOPOSmulti modules (8BxP/8B0C/8BVI/8BVE/8B0K)
Interface cards
5ACPCC.ETH0-00 PCIec Ethernet card 1x 10/100/1000 For APC820 and PPC800.
5ACPCC.MPL0-00 PCIec POWERLINK card, 2 POWERLINK interfaces, 512 kB SRAM; for APC820 and PPC800.
Automation Studio HW Upgrades Version (Date) Download
V3.0 HW Upgrade (5PC820.SX01-00) EXE / 671 KB
Documentation Version (Date) Download
Automation PC 820 User's Manual PDF / 9 MB
Driver Version (Date) Download
ADI driver APC820 (Win7 64-bit) ZIP / 1 MB
ADI driver APC820 (WinXP, Win7 32-bit) ZIP / 1 MB
Chipset driver 945GME/GM45 (WinXP, Win7 32/64-bit) EXE / 3 MB
Ethernet driver 945GME ETH1 (Win7 32/64-bit) ZIP / 6 MB
Ethernet driver 945GME ETH2 (Win7 32-bit) EXE / 30 MB
Ethernet driver 945GME ETH2 (Win7 64-bit) EXE / 34 MB
Ethernet driver GM45 ETH1/ETH2 (Win7 32-bit) EXE / 29 MB
Graphics driver 945GME (Win7 32-bit) EXE / 23 MB
Graphics driver 945GME (Win7 64-bit) EXE / 23 MB
E-CAD (Electro or EPLAN Templates) Version (Date) Download
APC EPLAN P8 from V2.4 EXE / 90 MB
Firmware Upgrades Version (Date) Download
APC820 Firmware Upgrade (MTCX, SDLR) ZIP / 635 KB
M-CAD (Mechan. Templates) Version (Date) Download
3D file DXF/STEP 5PC820.SX01-00 ZIP / 5 MB
Tools / Utilities / Examples Version (Date) Download
ADI .NET SDK ZIP / 2 MB
ADI Development Kit ZIP / 4 MB
HMI Diagnostics Utility (WES7, Win7, Win8.1, Win10) ZIP / 2 MB

Please choose country and language

B&R Logo